Is this floor hardwearing?

Yes, this floor has an AC5 rating, meaning it is suitable for commercial use

Do you need underlay with this product?

This range of floor comes with an underlay attached, so there is no need to purchase more underlay

What is this floor made of?

This range of flooring is made of Stone and PVC, making it extremely usable and 100% waterproof

How to take care of the floor?

We would recommend to clean this floor with a damp mop. no abrasive chemicals are recommended

Site preparation and subfloor
Remove all furniture and thoroughly brush and vacuum the subfloor. The surface must be clean, dry and level before fitting begins.
Check for uneven areas such as lumps, dips or protruding nails that could prevent the SPC from lying flat. Any irregularities greater than 2 mm over a 1 metre span should be levelled with a suitable floor levelling compound.
If fitting over new concrete, ensure it is completely dry which can take two to four months depending on depth and conditions.
Most SPC products include an integrated underlay so no separate underlay is required. If your product does not have an attached underlay, use only a thin non cushioned underlay that is approved for SPC flooring.

Expansion gaps
Leave a consistent expansion gap of 5 to 7 mm around the entire perimeter of the room including walls, door frames, pillars and fixed furniture such as kitchen islands.
When drilling around pipes, leave a 5 to 7 mm gap around the pipe.
Do not fix heavy objects directly to the floating SPC floor, as this can restrict natural expansion and contraction.

Tools and materials
Tape measure
Tri square
Spirit level
Pencil
Saw or Stanley knife
5 to 7 mm spacers
Rubber mallet
Pull bar and tapping block
SPC flooring planks

Installation guidelines
These are general SPC installation guidelines. Always read the manufacturer instructions supplied with your specific product before starting.

1. Begin in a corner and work left to right. Place the first board with the tongue side facing the wall and insert spacers to maintain the expansion gap.

2. Click the next board into place along the short end by inserting the tongue into the groove at an angle, then press down until it locks. Continue along the first row.

3. At the end of the row, measure and cut the last plank to fit, remembering to include the expansion gap.

4. Start the next row with the offcut from the previous row if it is longer than 30 cm, and stagger all end joints by at least 30 cm for a natural appearance.

5. Insert the long edge of each plank at an angle of about 25 to 30 degrees and gently lower it until it clicks into place. Use a rubber mallet and tapping block if needed to ensure tight joints.

6. Continue row by row. Measure and cut the final row to fit neatly against the wall while maintaining the expansion gap.

7. Remove spacers and fit skirting or trim to cover the expansion gaps.

After installation
The floor can be walked on immediately after installation.
Maintain room temperature between 18 C and 27 C for best performance.
If using underfloor heating, increase the temperature gradually at the start of the heating season and do not exceed a surface temperature of 27 C.

If you need assistance or advice, contact our team on 01 840 4458 or email hello@woodfloorstore.ie.

Regular Cleaning
Sweep or vacuum your SPC flooring regularly to remove dust and debris. Use a soft-bristle broom or vacuum with a hard-floor attachment to prevent surface scratches.

Mopping and Washing
Clean the floor with a damp mop using warm water or a neutral pH floor cleaner designed for vinyl or SPC flooring. Avoid excessive water — the surface is waterproof, but standing water can seep into joints and loosen adhesive trims over time.

Avoid Harsh Products
Do not use abrasive chemicals, wax, or solvent-based cleaners. Avoid scouring pads, steam cleaners, and high-pressure equipment, as these can dull the finish or damage click joints.

Prevent Scratches
Use felt pads or soft protectors under furniture legs. Avoid dragging heavy items directly across the surface. Place entry mats at doorways to catch grit and dirt that can mark the floor.

Temperature and Environment
SPC flooring performs best in room temperatures between 18°C and 27°C. Avoid long-term exposure to direct sunlight by using blinds or curtains, as intense heat can cause minor expansion or discolouration.

Spill and Stain Removal
Wipe up spills promptly with a dry or slightly damp cloth. For stubborn marks, use a mild detergent diluted in warm water. Avoid ammonia-based or acidic products.

Underfloor Heating Use
If fitted over underfloor heating, ensure the surface temperature does not exceed 27°C. Increase the heat gradually at the start of each heating season to prevent thermal shock.

Long-Term Care
Regularly check skirting, trims, and transitions to ensure they remain secure. If a plank becomes damaged, it can be replaced individually thanks to the SPC click system.

Call us on (01) 840 4458

Email us at hello@woodfloorstore.ie

Drop into our showroom, located at Old Airport Road, Santry, Dublin. K67 H0X9