iconBuy now,
Pay later
Wholesale
Prices Direct
Free
Samples
Nationwide
Delivery

Home / / Pergo Dark Grey Oak Laminate (Classic Plank 4V)

Pergo Dark Grey Oak Laminate (Classic Plank 4V)

Product Features

Water Resistant

Water Resistant

Scratch Resistant

Suitable for Underfloor Heating

Suitable for Underfloor Heating

AC4 Rated

AC4 Rated

Click Installation

Click Installation

High Quality

High Quality

Room Suitability

Bedroom

Dining Room

Living Room

Hallway

Hallway

Conservatory

Kitchen

Product Specifications

Length:

1380mm

Thickness:

9mm

Installation Method:

Click and Tap

Width:

190mm

Box Size:

1.573m sq

Finish:

EIR (Embossed in Register)

With their matt finish, Modern Plank Sensation floors have a realistic wood-like look that is hard to tell from the real thing. The innovative AquaSafe technology lends excellent water resistance for durability and security.

How to take care of the floor?

We would recommend to clean this floor with a damp mop. No abrasive chemicals are recommended.

 

How much floor should i order to ensure i have enough?

For our straight plank floors, we would recommend adding on 5% to the area you are covering to account for waste.

 

Does this floor require an underlay?

Yes, all laminate flooring require underlay. We have a number of underlay available to suit any need.

Site Prep, Subfloor and Underlay

One of the most important stages to consider prior to laying any type of flooring installation is site prep.

Remove all furniture from the room, brush and vacuum the sub-floor.

When fitting any flooring a key factor in site preparation is ensuring the subfloor is level. Take time to look for any unevenness in the surface. This could be nails, lumps of concrete or generally anything that would obstruct the vinyl from being laid perfectly flat. In some cases, levelling compound or sheets of plywood may be needed to achieve this. Also, test for dips or humps in the sub-floor using a long straight edge such as a spirit level. Place it in multiple areas of the room and get down low to look for any potential dips or humps. Anything over 2mm in a 1 metre run should be levelled out using a suitable floor levelling compound.

If you are laying onto a new concrete sub-floor, check that it is fully dried which can take anywhere from 2 - 4 months.

Most underlays are suitable to use with vinyl flooring. When choosing your underlay, you may decide to go for a noise-reducing underlay, typical foam underlay or one suitable for underfloor heating.

Expansion Gaps

It is vital to leave a consistent expansion gap of 7-10mm at walls, pillars, stairs, doorways and other fixed objects or boarders in the room such as kitchen islands or fitted wardrobes. When drilling a hole for pipes, the hole should be 7-10mm larger than the pipe itself. Objects should not be fixed to a floating floor as this prevents the floor from expanding or contracting when needed.

Materials needed:

Tri square 

Tape measure

Spirit level
Ruler
Pencil
Saw or stanley knife 7 - 10 mm spacers Rubber mallet Underlay

Flooring Pencil

Installation Guidelines

*** These instructions are a guide only. If you are unsure about anything you should refer to the instructions provided with your materials. ***

Start in a corner and work left to right. The end with a shorter tongue should be placed against the wall. 7 - 10mm expansion spacers should be used along the wall to maintain a consistent gap. The gap will allow for any natural expansion in the future that comes with changing seasons. Without this gap, you may encounter some issues with your vinyl floor.

The second board should be laid fitting the tongue and groove mechanisms together. It is always best to refer to the specific brand’s guidelines as these grooves differ between brands. Repeat this process until the end of the row.

In the case that the last board of the row is too long, you will need to cut this down to fit with a saw. Remember to account for the expansion spacer in this measurement. Turn the board 180 degrees in order to measure accurately and lay next to the previous board laid. After cutting, place the board down with the cut side next to the wall.

The typical design for laying wooden floors is to keep the ends of the boards approximately 30 cm apart. If the cut off board from the previous row is longer than 30cm, use this as the first board of the second row. The freshly cut side should always face the wall. However, if it’s too short, you can cut down another board to use instead. It is advised to keep a consistent length of 30cm between the ends of the boards in order to maintain this look.

In most cases, you will need to fit long edges together at 30 degrees from the floor before lowering it and locking it in place. The boards should then slide together into place. This is only the case for most brands so the manufacturer’s guidelines should always be considered.

If any last boards need to be cut lengthways, you can use another board to guide any markings needed before cutting.

Assuming these guidelines are followed and the manufacturer’s instructions are studied accordingly, there should be no issues with laying a vinyl floor.

Protection and Cleaning

  • Use wood flooring felt pads on heavy furniture and chairs that will be used frequently.
  • Check shoes, especially heels and football boots for any metal or hard materials that may damage your floor.
  • Install door mats at entrances to help remove anydirt, stones, and moisture from the bottom of shoes.
  • Heat should be maintained between 15-28°C to avoid excessive movement.

Contact us

Product Details

With their matt finish, Modern Plank Sensation floors have a realistic wood-like look that is hard to tell from the real thing. The innovative AquaSafe technology lends excellent water resistance for durability and security.

DIMENSIONS

Length1200 mm
Width190 mm
Height8 mm
m²/pack1.596 m²
Planks/pack7 planks
Number of grooves0 bevels

TECHNICAL DATA

Usage classClass 32 - Fit for all-round domestic use
Installation methodClick installation
Click systemUniclic
Water resistant technologyAquasafe
Surface ProtectionTitanX
Floor HeatingCompatible with floor heating
ColorDark grey
Pattern1 strip
Wood speciesOak
Type of groovesNo bevel
Gloss levelSilk matt, SemiMattGroup
FAQ’s

How to take care of the floor?

We would recommend to clean this floor with a damp mop. No abrasive chemicals are recommended.

 

How much floor should i order to ensure i have enough?

For our straight plank floors, we would recommend adding on 5% to the area you are covering to account for waste.

 

Does this floor require an underlay?

Yes, all laminate flooring require underlay. We have a number of underlay available to suit any need.

Maintenance

Protection and Cleaning

  • Use wood flooring felt pads on heavy furniture and chairs that will be used frequently.
  • Check shoes, especially heels and football boots for any metal or hard materials that may damage your floor.
  • Install door mats at entrances to help remove anydirt, stones, and moisture from the bottom of shoes.
  • Heat should be maintained between 15-28°C to avoid excessive movement.

Protection and Cleaning

  • Use wood flooring felt pads on heavy furniture and chairs that will be used frequently.
  • Check shoes, especially heels and football boots for any metal or hard materials that may damage your floor.
  • Install door mats at entrances to help remove anydirt, stones, and moisture from the bottom of shoes.
  • Heat should be maintained between 15-28°C to avoid excessive movement.
Contact Us

Contact us

Can't find the flooring you've dreamed of?
Get in touch today

Classic Plank

About The Brand

A beautiful laminate floor in classic plank length. This floor features a Genuine™ wood texture, a lightly polished structure that follows the wood grain in every detail, complemented by a silk matt finish. The living Expression quality level is suitable for all-round domestic use